legines.com

Points to note when installing and using oil pipe joints

Release time:
Abstract:The tubing joint is actually one of the quick join...
The tubing joint is actually one of the quick joints. The quick couplings can be divided into: quick couplings for air, quick couplings for oxygen, fuel gas, common quick couplings for gas and liquid, quick couplings for oil pressure, quick couplings for inert gas, quick couplings for cooling water and temperature oil, semiconductor quick couplings, and so on.





But today, I still want to tell you what you need to pay attention to when using tubing in many types of joints. When using this type of connector, be careful not to use it for fluids other than the applicable fluid. Do not exceed the maximum use pressure limit when in use. Do not use it outside the operating temperature range to prevent wear or leakage of the sealing material. Do not hit, bend, or stretch artificially to prevent damage. Do not use it in places mixed with metal powder or sand to prevent poor work or leakage.



If you want to get a good use of tubing joints, you must not only pay attention to the use, but also pay attention to the installation of the joint installation thread, and do not exceed the maximum tightening torque during installation to prevent damage. Do not use hoses with cracks to prevent leakage or falling off. If it is used in a machine subject to vibration or impact, the durability will be reduced. The fluid used must be a clean fluid filtered by a filter.