Precautions for Installation of Stainless Steel Hydraulic Fittings

Release time:
Abstract:Stainless steel hydraulic fittings are suitable fo...
Stainless steel hydraulic fittings are suitable for high pressure, vibration, and high sealing conditions. The sealing performance, compression resistance and shock resistance of pipe joints are improved. So what should be paid attention to in the installation of stainless steel hydraulic joints?

Stainless steel pipe fittings have excellent direct butt joint performance, and have high requirements for drain pipes, cast iron drain pipes, pipe diameter ovality, pipe wall thickness and physical properties of rubber rings. This is a common problem in installing stainless steel hydraulic joints. The preconditions for sealing performance are poor, coupled with strict control of the quality of pipe fittings and pipe fittings, high-pressure pipe fittings also pay special attention to the number of pipe fittings and pipe fittings, the ovality of pipe flanges and the number of elbows at the joint inspection port. In the construction of equipment engineering, the actual operation process should be strictly followed.

Stainless steel seamless splicing pipe is a strip of stainless steel plate with a hollow section and no joints nearby. The thicker the thickness of the stainless steel seamless pipe, the more reasonable the thickness of the pipe, the more common, the thinner the wall thickness, the greater the production cost.

The pipeline is a hollow pipeline, which is a solid chemical pipeline such as a pre-injected liquid pipeline, a pre-injected gas pipeline, a crude oil pipeline, a liquefied gas pipeline, and a water purifier pipeline. Compared with solid stainless steel plate, stainless steel seamless steel pipe is an economical profile stainless steel plate, which has the same bending strength, torsional strength and compressive strength as the net weight, and is widely used in steel pipe scaffolding, bicycle frames, transmission shafts, crude oil drills For the manufacture of mechanical parts such as utensils, if the distance between the sleeves of the horizontal riser and the sanitary ware does not exceed 600mm, brackets can be set in the management center.