It is very important to control the installation tightness of the transition joint

Parts such as transition joints must be well assembled on the basis of their own reliable quality. Only in order to give full play to the advantageous functions in use, to ensure reliable applications. From the point of view of the requirements of the use of the joint, it is very important to control the tightness in the assembly.


Because if the transition joint is not installed tightly enough, it will lead to insufficient connection. This will inevitably lead to leakage problems in the pipeline system. For many systems that require the use of functional joints, the existence of leakage not only wastes materials, but also affects the normal operation and use of the entire system, and may also bring potential safety hazards.





But this is not to say that it is enough to blindly tighten the transition joint when assembling the transition joint, because the joint is not only installed too loosely and there is a problem, but it is also possible that some undesirable conditions may occur if the installation is too tight. If there are too many fastening operating sleeves, it is possible that the joint will be damaged under the condition of huge external force. As long as the screw is fastened too much, it is easy to have slippage, resulting in the failure to fasten it again. This kind of phenomenon will also exist in the assembly of the joint.


Therefore, from the perspective of use, it is very important for everyone to pay attention to control the installation tightness of the transition joint, and neither install it too loose nor too tight. It is that the tightness is in the right state, which is most conducive to the optimal use of the joint, so that it can function reliably in use.