Pay attention to controlling tightness when installing hydraulic transition joints

The realization of the optimized application of hydraulic transition joints requires everyone to ensure that the product has a very tight installation effect and that the connection is very firm and reliable. However, we should also remind everyone to pay attention to the fact that the joints are required to have a tightening installation effect. It does not mean that they must be tightened continuously during installation. This may also cause damage to the joints.


Therefore, when installing hydraulic transition joints, regarding tightness, it is important that everyone pay attention to control and ensure that the tightness is appropriate. Whether it is installed too loose or tightened too much, it will cause adverse effects. of. If the joints are not fastened enough and the installation is too loose, the connection parts will inevitably not be strong enough, and there will be leakage problems. These will cause great adverse effects and affect the use of the entire equipment system.




Excessive tightening of hydraulic transition joints when installing hydraulic transition joints may result in too much tightening operation, resulting in a certain amount of damage to the joints under the action of huge external force, which is not only unfavorable for the joints to achieve a firm tightening state, but may also Damage the connector, causing it to not continue to be used normally, which will cause losses to everyone.


Therefore, when installing hydraulic transition joints, you need to pay attention to control the tightness, not only to ensure that the installation is sufficiently tightened, but also to avoid excessive tightening operations.